To improve print quality and reduce common printing issues, follow these recommendations:
• Load Filament Manually: Do not use an automatic filament feeder. As a flexible filament, PEBA 90A may experience feeding issues or nozzle clogging during automatic loading and unloading. Always load and unload the filament manually.
• Choose a Suitable Nozzle Size: Use a nozzle with a diameter of 0.4 mm or larger. Recommended nozzle sizes are 0.4 mm, 0.6 mm, and 0.8 mm. Do not use nozzles smaller than 0.4 mm.
• Disable Dynamic Flow Calibration: Turn off Dynamic Flow Calibration before printing to prevent compression and deformation of the flexible filament from affecting calibration results and print quality.
• Reduce Bubbles and Stringing: Bubbles or excessive stringing on the printed surface usually indicate that the filament has absorbed moisture. Thoroughly dry the filament at 75°C for 8 hours before printing again.
• Improve Overhang Cooling: If the surface of an overhang begins to sag, set the cooling fan to 100%. You can also orient the affected area toward the fan and move the model closer to it to improve local cooling.
• Prevent Excessive Build Plate Adhesion: PEBA 90A may adhere too strongly to the build plate, and removing the model directly may damage its bottom surface. Apply an even layer of glue stick to the build plate before printing. After printing, spray a small amount of alcohol around the contact area between the model and the build plate. Allow it to seep underneath the model before carefully removing the print.
• Improve Support Results: Use PETG or PLA as the support material for better overhang surface quality and easier support removal.